Home > News

What Should I Do If The Printer Prints Out The Word Is Not Clear?

Oct 31 , 2019

The printer's unclear print may be caused by insufficient ink. If there is enough ink, it may be due to a problem with the print head. You can try to select [Maintenance] - [Clean] in [Printer Preferences]; It is recommended that the printer be unclear and sent to the after-sales service inspection. The Desktop PVC Smart Card Printer Manufacturer below is introduced in detail.


1. Double-click the icon of the printer in the status bar in the lower right corner of the system to check whether the ink is insufficient in the status of the printer. If it is insufficient, please replace it in time;


2. If there is ink, it may be due to the print head. Open the [Control Panel] - [Devices and Printers] option, find the right printer to use and select [Printing Preferences], select the [Maintenance] tab, and click [Print]. Head cleaning], click [Start] to clean;


3. If there is such a problem with the laser printer, it is recommended not to disassemble it at will. In most cases, there is a problem with the fixing unit. The best way is to send it for repair, so as to avoid unnecessary machine damage.


Ink cartridge for Mimaki


Ink cartridge for Mimaki


There are also different reasons for different types of printers.


1. For inkjet printers, there may be two reasons. The ink cartridges are exhausted, the printer is not used for a long time, or the nozzle is blocked by direct sunlight.

The solution is: you can replace the Ink cartridge for Mimaki or ink, if the cartridge is not used up, you can conclude that the nozzle is clogged. Remove the ink cartridge and soak the nozzle in warm water for a while. Be careful not to immerse the board in the water, otherwise the consequences will be unimaginable.


2. For the dot matrix printer, there may be the following reasons: the print ribbon is used for a long time; the print head is not cleaned for a long time, there is too much dirt; the print head has a broken needle; the print head drive circuit is faulty.

The solution is: first adjust the distance between the print head and the print roller, the fault can not be ruled out, you can replace the new ribbon, if not, you need to clean the print head.

Remove the two fixing screws on the print head, take off the print head, and use a needle or a small hook to remove the dirt from the front and back of the print head. Generally, the ribbon fibers are accumulated for a long time.


Then, in the back of the print head, a few drops of instrument oil can be seen in the place where the needle is seen, in order to remove some dirt, do not put a few sheets of paper in the ribbon, and then install the ribbon, so that the problem can be basically solved, if it is If the print head is broken or the drive circuit is defective, only the print pin or the drive tube can be replaced.


Whether it's a dot matrix printer, an inkjet printer, or a laser printer, this is often a hardware failure. We can use line observation to focus on the key components of the printer.


Taking the Sublimation Machine Inkjet Printer as an example, if the color of the printed product is blurred and the font is not clear, the fault can be locked in the nozzle, and the machine is automatically cleaned (according to the manual), if it is not used for a long time. If you print, you should wash it a few more times.


You can also carefully remove the ink cartridge and wipe it clean with a soft, absorbent paper near the printhead. If it still can't be solved, it may be a problem with the driver. Generally, it will be re-installed again.


When editing a file with word and other software and printing it with a printer, it is obvious that the words are arranged neatly in the print preview, and some text overlaps on the printed paper. This phenomenon is generally due to setting during editing. Improperly adapted, change the paper size, paper type, number of words per line, etc. in the file page properties, generally can solve the problem of incomplete writing or unclear writing by simple processing.