Home > News

Step 1: is to first remove the sealing patch on the HP DesignJet Water Based Ink filling hole, and then press the steel ball in the ink filling hole into the box with the thin end of the pushing bead tool.


HP DesignJet Water Based Ink Filling Technique For Ink Cartridges

Apr 28 , 2019

Step 1: is to first remove the sealing patch on the HP DesignJet Water Based Ink filling hole, and then press the steel ball in the ink filling hole into the box with the thin end of the pushing bead tool.

Step 2: Remove the rubber cap from the ink cartridge, insert the ink cartridge mouth into the short needle and press it tight.

Step 3: First fasten the nut into the top of the Galaxy Eco Solvent Printer Ink cartridge, insert the ink cartridge into the ink injection hole, and screw the screw into the nut hole.

Step 4: Rotate the screw to push the piston slowly until all the ink is injected into the cartridge (note: two inks must be added at a time).

Step 5: Remove the ink cartridge, place a new steel ball in the ink hole, and gently press the steel ball with the thick end of the bead tool until it is flush with the hole. Then attach a circular patch.

Step 6: Attach the ink nozzle of the ink cartridge to the rubber button, and press the tail of the ink cartridge firmly to make it fit into the protective clip.

Step 7: Remove the short needle of the empty ink cartridge, insert the mouth of the ink cartridge into the rubber key hole, and press it tightly. The anti-rotation screw causes the piston to bounce, sucks out 2-3 mm of ink, and then gently removes the ink cartridge.

Finally, remove the ink cartridge from the protective clip and wipe it off with a clean paper towel to install it for use. At this point, the entire process of ink filling is over and your printer can start a new job.

HP DesignJet Water Based Ink